It is never too early to make holiday greeting cards. This simple Santa snowflake card was made with rubber stamping, coloring and a layered embellishment. This is a fun project to chip away at those handmade Christmas cards. This project is also up on the Unity Stamp Co. blog today.
Helpful tips:
In summary, to make this card, begin by preparing an A2 sized card base in white. Then using a paper trimmer, make a colored background frame panel in blue a bit smaller than the card base. Next, on white cardstock, stamp the large Santa and the sentiment close together using alcohol friendly ink. Then, add color to the Santa. Also, trim or die-cut the stamped panel to fit inside of the blue frame layer. Next, for the embellishment, die-cut two snowflakes in silver card stock. Pierce a hole in the center of each, layer them together and fasten them to the Santa panel using a small brad. Finally, adhere all of the layers onto the card base, to finish.
Here is the Santa card a bit closer.
Although silver cardstock is not necessary for the snowflake, the shine looks beautiful when the light captures it. Any color works just fine.
This is a peek at how this card was made.
Don't forget to check out
Amazon for craft supplies.
Gaylynn
{{ Don't miss my crafty news. Sign up for my emails below. }}
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.